What ASIC Package Size is Needed to Get Past 224G?
224G PAM-4 differential pairs must operate in TEM propagation modes to ensure broadband signals can reach a PCB and other components.
Read Article
Solving electromagnetic, RF, thermal, and SI/PI simulation challenges to ensure your system works
224G PAM-4 differential pairs must operate in TEM propagation modes to ensure broadband signals can reach a PCB and other components.
Read Article
224G PAM-4 systems use data rates that require 56 GHz Nyquist frequencies. Can skip-layer routing work in these component packages?
Read Article
Enclosures for a PCB assembly can help with thermal management by providing directed airflow and functioning as a large heat sink.
Read Article
Configuration signals in an embedded system can connect to many different components. How fast do these signals need to be, and can you slow these down?
Read Article
An electronic DC load is an essential piece of equipment for any lab. Learn about the operation of these units for power supply testing.
Read Article
Error - something went wrong!
Want the latest in Computational Fluid Dynamics?
Thank you!
All heat pipes include a working fluid that is responsible for heat transfer away from a hot component.
Read Article
Oscillating heat pipes are newer technologies that can be difficult to build, but they offer advantages over conventional heat pipes.
Read Article
Evaluate Your RF/Microwave Design Needs
Start Free TrialA heat pipe is one option that provides high heat flux for use in industrial systems, aerospace, data center equipment, and much more.
Read Article
Mechanical assemblies also have to follow DFM rules to ensure they can be fabricated and assembled at scale.
Read Article
Data center architecture is built on the switched fabric topology using point-to-point communication for high through-put data transfer.
Read Article
InfiniBand is one of the primary interconnects used in data center architecture. Learn about its capabilities in this article.
Read Article
Full-wave electromagnetic simulations, quasi-static simulations, and simpler 2D simulations all require the use of correct boundary conditions.
Read Article
PCB assembly defects on leadless components can lead to open circuits that are difficult to diagnose.
Read Article
Semiconductor IP can experience the same kind of seamless handoff as other forms of product data with the IEEE 1685 standard, known as the IP-XACT standard.
Read Article
MRP, ERP, and PLM systems are just a few of the enterprise management tools used by OEMs and electronics manufacturers.
Read Article
Glow wire testing is used in PCB connectors to ensure they can tolerate high currents that may lead to very high temperatures.
Read Article
PFAS can be found in electronic components, cables, and circuit boards, as well as other portions of an electronics assembly.
Read Article
The Venturi effect equation is a fundamental aspect of many common applications. However, complex applications require advanced CFD solver capabilities.
Read Article
If you have a reference oscillator for an RF ADC, what is the level of phase noise you should accept on your oscillator?
Read Article
The enhancements in the new CXL 3.0 standard take advantage of the bandwidth increase in the PCIe 6.0 standard.
Read Article
Loading More...