Skip to main content

System Analysis

PCB Design & Analysis

Cadence System Analysis

- eBooks
- White Papers and Conference Papers
Latest Blogs
View All
Contact Us

Recent Searches

Share this Post

Share on facebook
Share on twitter
Share on linkedin
Share on email

Home
AWR Design Forum
RF/Microwave Design in Teaching

RF/Microwave Design in Teaching

Published Date October 21, 2021

In this video, David Vye talks with Dr. Zoya Popovic of University of Colorado Boulder regarding the use of AWR software in education.

Previous Video

Active and Passive Matching in RFPAs: A Quirky Partnership

This talk will discuss some of the potential benefits, but also the possible hazards, of this approach in PA design.
Next Video

An Enhanced Design Flow for Cavity Combline Filters

Cavity combline filters and multiplexers are widely used in commercial and military systems. Many of these filters use finite transmission zeros to increase selectivity in the stopbands, which...

Most Recent Videos

over 2 years ago
HPA Design for Satellite Communications

In this video David Vye talks with Thomas Young of Arralis about the K-band satcom GaN HPA design using AWR software. https://www.arralis.com/

Watch Video
over 2 years ago
RF Link Budget Analysis Using Visual System Simulator

This video presentation demonstrates how to use the RF modeling capabilities in Visual System Simulator software for RF link budget design and analysis.

Watch Video
over 2 years ago
Phased-Array Antenna Simulation for 5G

This presentation introduces capabilities that guide engineers through the design, analysis, and physical realization of new arrays, incorporating real-world radiation patterns, RF links, etc.

Watch Video
over 2 years ago
Phase Noise Modeling Using AWR Software

This presentation explains how to use the Visual System Simulation time-domain engine to measure phase noise.

Watch Video
over 2 years ago
MMIC PA Design for 28 GHz 5G Applications Using UMS GH15 Gan-on-SiC

This talk introduces the United Monolithic Semiconductors foundry and its processes, followed by highlights of techniques supporting device modeling of III-V wide bandgap semiconductor technology.

Watch Video
over 2 years ago
Best Practices for Efficient and Effective EM Simulation

The best practices address four main design areas: ports, EM environment, meshing, and simulation.

Watch Video
over 2 years ago
Input and Output Controlled High-Efficiency PAs

This presentation discusses the design of efficiency-enhanced PAs by concurrently controlling input and output harmonics.

Watch Video
over 2 years ago
EM Simulation for RFIC Silicon

This talk will present examples using the Cadence EM simulators, AXIEM 3D planar method-of-moments (MoM) and Analyst™ 3D finite-element method (FEM), to address EM simulation issues for silicon.

Watch Video
over 2 years ago
Doherty PA Design from Load-pull Derived EPHD Models

This talk presents basic Doherty PA theory and design methodology featuring specific simulation and design automation capabilities within Microwave Office circuit design software.

Watch Video
over 2 years ago
Designing a Narrowband 28-GHz Bandpass Filter for 5G Applications

This presentation takes a look at the filter design challenges brought on by adopting these new technologies and the factors driving the physical, electrical, and cost restraints for 5G filters.

Watch Video
over 2 years ago
Wolfspeed RF Device Modeling

The presentation will cover the core aspects of Wolfspeed nonlinear GaN HEMT model.

Watch Video
over 2 years ago
Challenges Around GaN-on-SiC at High Frequencies

GaN technologies for RF/mmWaves require techniques to unleash the full potential of short gate-length GaN-on-SiC HEMT processes. Different challenging cases will be addressed during the presentation.

Watch Video
over 2 years ago
Modeling the Coupled Effect Between Antenna Arrays and Nonlinear RF Front Ends

This presentation highlights the use of VISION models in AWR software to address complex systems' design and simulation, accounting for nonlinearities, inter-block mismatches, and memory effects.

Watch Video
over 2 years ago
GaN/SI Microwave Process for 5G High-Power and Low-Noise Applications

This presentation will describe the OMMIC GaN solution for microwave and mmWave PAs.

Watch Video
over 2 years ago
Active and Passive Matching in RFPAs: A Quirky Partnership

This talk will discuss some of the potential benefits, but also the possible hazards, of this approach in PA design.

Watch Video
over 2 years ago
An Enhanced Design Flow for Cavity Combline Filters

Cavity combline filters and multiplexers are widely used in commercial and military systems. Many of these filters use finite transmission zeros to increase selectivity in the stopbands, which...

Watch Video
over 2 years ago
Addressing Instability in Wide Bandwidth High Power Amplifiers (HPAs)

This webinar presents the use of stability analysis techniques to identify potential instability in a 200-W PA and design techniques to stabilize the amplifier.

Watch Video

Return to Home

© Cadence Design Systems, Inc.

Untitled Document

A Great Place to Do Great Work!

Seventh year on the FORTUNE 100 list

Our Culture Join The Team

Products
Custom IC and RF
Digital Design and Signoff
IC Package
IP
PCB Design
System Analysis
Verification
All Products

Company
About Us
Events
Leadership Team
Investor Relations
Alliances
Careers
Cadence Academic Network

Media Center
Newsroom
Designed with Cadence
Blogs
Forums

Contact Us
General Inquiry
Customer Support
Media Relations
Global Office Locator

© Cadence Design Systems, Inc. All Rights Reserved.

Terms of Use Privacy Policy US Trademarks Do Not Sell My Personal Information

Connect with us